Conical Mandrel Bend Tester
The Conical Mandrel Bend Tester offers a practical means to determine the ability of a coating to resist cracking and or detachment when being subject to bending around a conical mandrel, additionally flexibility properties can also be determined on flexible substrates.
For a multi-coat system, each coat may be tested separately or as a complete system.
Method of use
Set the operating arm of the drawbar over the clamping plate and place the panel with the coated side facing the clamping plate and hold with the securing screws.
Note: To prevent the coating being damaged during bending by the drawbar, place a piece of paper between the coated side and the drawbar.
Move the operating lever through approximately 180º angle at a uniform speed over 2- 3 seconds.
If the purpose of the test is to determine elongation of the coating, the operating lever should be rotated more slowly over approximately 15 seconds.
View the coating immediately either visually of with a times 10 magnification. Determine the length of the crack, (measured from the small end of the mandrel) calculate the mean of three determinations.
The position where the crack stops can be taken as the point of resistance to cracking.
- 200 mm long panel capacity
- Conical Mandrel diameters, 38 mm down to 3 mm at the small end
- Study construction
- Long service life mandrel
- Stainless Steel Conical Mandrel and Roller
- Four holes in the base for securing to a workbench
ASTM D522 Test Method A
BS 3900 E11
Get a quotation
|SKU||Name||Add to quote|
|SH801||Conical Mandrel Bend Tester|
To request a quotation please click the "Add to quote" button next to each product you require.
Then select the "View and send my quotation" button above or at the top to review and send your quotation.
If you cannot find the product you are looking for, or have an additional request for a product please fill in our enquiry form.